Lenze E82ZAFPC010 Manual do Utilizador descarregar pdf (Página 53)

Electrical installation

Wiring according to EMC

EDK82ZAFPC-010 DE/EN/FR 6.0



H2_EMV_Verdraht-VorgehenVerdraht

Wiring according to EMC

For wiring according to EMC requirements observe the following points:



Note!

Separate control cables/data lines from motor cables.

Connect the shields of control cables/data lines

at both ends

in the case of

digital signals.

Use an equalizing conductor with a cross-section of at least 16 mm

(reference: PE) to avoid potential differences between the bus nodes.

Observe the other notes concerning EMC-compliant wiring given in the

documentation for the standard device.

Wiring procedure

1. Observe the bus topology, do not use any stubs.

2. Observe the notes and wiring instructions given in the documents for the control

system.

3. Only use cables corresponding to the listed specifications (56).

4. Observe the notes for the voltage supply of the module (58).

5. Activate the bus terminating resistors on the first and last physical bus device

(68).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 105 106

Sem comentários

Lenze E82ZAFPC010 Manual do Utilizador Página 53