Lenze SS208AC Manual do Utilizador descarregar pdf (Página 14)

SimpleServo 100/200 User Manual Rev 3.4

CONNECTORS

AC power in (AC models only)

This power entry connector located on the bottom and made to accommodate standard 3-prong computer

AC cable plug.

WARNING!

DO NOT connect incoming power to the output motor terminals (U, V, W)!

Severe damage to the SimpleServo will result.

Note:

All conductors must be enclosed in one shield and jacket around them. The shield on

the amplifier end must be terminated at the case (chassis ground); the other end

should be properly terminated at the motor shield. To satisfy CE requirements, AC

Technology Corp recommends that you purchase SimpleServo cables for both the

motor and AC line. Contact your AC Technology Corp representative for assistance.

DC power in (DC models only)

DC power is connected via terminals 1 and 2 on TB1 connector. See description of TB1 functions below.

WARNING!

DO NOT connect incoming power to the output motor terminals (U, V, W)!

Severe damage to the SimpleServo will result.

TB1 - Power (DC units only), Motor and Fuse Connections

Table 3. TB1 Pin Assignments

Terminal Block Pin # Name FUNCTION

1 W (T) +DC in (DC models only)

2 V (S) -DC in (DC models only)

3 W (T) Motor Power Out

4 V (S) Motor Power Out

5 U (R) Motor Power Out

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Sem comentários

Lenze SS208AC Manual do Utilizador Página 14