Lenze Loader L-force Loader Manual do Utilizador descarregar pdf (Página 39)

L DMS 4.0 EN - 07/2007 39

L-force Loader

Appendix

Error numbers, causes & remedies

Error while downloading L-force 9400 application

8000C702h Controller inhibit has not been set. Set controller inhibit on the target system.

8000C704h Application has not been stopped. Stop the application on the target system.

8000C801h Error message of target system while

downloading.

Restart target system to establish the "ready

for download" state.

8000C807h Error message of target system:

Licence level does not correspond.

Create the application again using the

Engineer and transfer it to the target system

or update the target system.

8000C808h Error message of target system:

Target does not correspond.

8000C809h Error message of target system:

Error while configuring the module.

8000C80Ah

8000C8xxh Other (not yet listed) error messages of the

target system while downloading.

Create the application again using the

Engineer and transfer it to the target system.

Errors within the DriveServer

E7C18000h Error during download preparations. Repeat download.

E7C18001h PLC has not been stopped. Stop the PLC program on the target system.

E7C18002h Controller inhibit has not been set. Set controller inhibit on the target system.

E7C18003h Incorrect file type (no LC9 file). Create new LC9 file.

E7C18004h Checksum test is negative (incorrect

checksum).

Repeat download.

Increase time-out time in the system bus

configurator (e.g. to 3 seconds).

E7C18005h Item can momentarily not be accessed due to

download.

Repeat download after a few minutes or

restart your PC.

E7C18006h Target system is momentarily busy copying

RAM blocks.

Start the PLC program on the target system.

E7C18007h Error occurred after the download. Repeat download.

E7C18008h Error after version comparison during

download of an LC7 file.

• Different versions in LC7 file and target

system.

Update the operating system for 9300 EK.

E7C18009h "Cam" template is not available on the target

system.

Create DDS project based on Cam template

and transfer it into the target system.

Error number Cause Remedy

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45

Comentários a estes Manuais

Sem comentários

Lenze Loader L-force Loader Manual do Utilizador Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com Software Lenze Loader L-force Loader