Lenze 2131IB Manual do Utilizador descarregar pdf (Página 40)

Parameter setting

6-17

 BA2131EN

The actual unit status can only be clarified by combining the unit-status information bits (bit 0 to 6).

This is shown in the following:

Unit status Bits of the status word

Bit 6 5 4 3 2 1 0

NOTREADYTOSWITCHON 0 0 0 0 0

SWITCH-ON INHIBIT 1 0 0 0 0

READYTOSWITCHON 0 1 0 0 0 1

SWITCHED ON 0 1 0 0 1 1

OPERATION ENABLED 0 1 0 1 1 1

FAULT 0 1 0 0 0

FAULT REACTION ACTIVE 0 1 1 1 1

QUICK STOP ACTIVE 0 0 0 1 1 1

Switch-on inhibit

Quick stop

Voltage inhibit

Fault

Operationenabled

Switched on

Readytoswitchon

Explanation:

0 = Bit status is 0

1 = Bit status is 1

empty = Any bit status, no influence

6.5.3 Control word

Note!

The single bit control commands of the control word depend on other bit positions. Chapter 6.5.2

describes the bits required to effect the command.

Show/Hide Bookmarks

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Sem comentários

Lenze 2131IB Manual do Utilizador Página 40