Lenze MC1000 Series Manual do Utilizador descarregar pdf (Página 38)

34 13435742_EDBM101_v24

15 MC1000 CONTROL WIRING DIAGRAMS

15.1 MC1000 TERMINAL STRIP

Shown below is the terminal strip on the main control board, along with a brief

description of the function of each terminal. Wiring shown above the terminal strip

indicates internal wiring on the main control board.

FORM C

RELAY

1 2 5A 5B 6 10A 12A

RXA

TXB10B 2 13A 13B 13C 13D 14 15

16 17 18

STOP

CIRCUIT COMMON

0-10 VDC SPEED REFERENCE INPUT

10 VDC SUPPLY FOR SPEED POT

0-10 OR 2-10 VDC OUTPUT: FREQUENCY

0-10 OR 2-10 VDC OUTPUT: LOAD

CIRCUIT COMMON

START

TB-13A FUNCTION SELECT

TB-13B FUNCTION SELECT

TB-13C FUNCTION SELECT

TB-13D FUNCTION SELECT

OPEN-COLLECTOR OUTPUT

RS-485 SERIAL

COMMUNICATIONS

CIRCUIT COMMON

4-20 mA SPEED REFERENCE INPUT

The TB-2 terminals are internally tied together

NOTE

The function of terminals TB-10A, TB-10B, TB-13A, TB-13B, TB-13C,

TB-13D, TB-14, TB-15, TB-16, and TB-18 are dependent on the

programming of certain parameters. In most cases, the name of the

parameter matches the number of the terminal, allowing quick and easy

programming of the terminals to suit the application. The exception is

TB-16 and TB-18, which are governed by Parameter 54 - RELAY.

A complete description of operating the drive in the REMOTE mode can be found

in Section 14.2. The following diagrams provide a quick reference to wire the drive

for the most common congurations.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 83 84

Sem comentários

Lenze MC1000 Series Manual do Utilizador Página 38