Lenze Engineer v2.21 Manual do Utilizador descarregar pdf (Página 282)

Appendix

Creating cam data with the »Cam Editor«

282

Lenze · Engineer · 2.13 EN - 10/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

ViewInterpolation mode Change to the interpolation mode.

• Starting from an ideal, complete cam that was calculated

in connection mode, table interpolation is carried out. The

table contains the interpolation points of a linear

interpolation.

• Note: The button is only active in the Expert mode of the

»Cam Editor«!

•If the Expert mode has been deactivated, all the

necessary steps automatically take place when the

buttons Curve mode and/or Interpolation mode are

clicked.

EditStart calculation... Calculate cam in the connection or interpolation mode and

arrange interpolation points optimally.

• Note: The button is only active in the Expert mode of the

»Cam Editor«!

•If the Expert mode has been deactivated, all the

necessary steps automatically take place when the

buttons Curve mode and/or Interpolation mode are

clicked.

Icon Menu command Function

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 311 312

Sem comentários

Lenze Engineer v2.21 Manual do Utilizador Página 282