Lenze Engineer v2.21 Manual do Utilizador descarregar pdf (Página 300)

Appendix

User motors

300

Lenze · Engineer · 2.13 EN - 10/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

14.4.5 Transferring default values to the controller

If a controller has already been connected to a user motor in your project, the default values saved

in the motor can be transferred once again to the controller. This will reset settings that might have

been changed to the default values.

For this purpose, use the "Motor parameter" tab of the respective user motor.

 How to transfer the default values to the controller:

1. Create an »Engineer« project including a user motor.

2. Highlight the user motor.

Area Functions



Data and default values of the user motor



Parameters of the controller connected

 Note!

• The button for transferring the default values is only activated if the controller group

suitable for the controller connected has been selected in the control field of the tab.

• If the drive controller is online at this point in time, the default values are transferred

to the offline and online values of the relevant codes of the drive controller.

• If the controller is in offline mode, the default values will be transferred to the offline

values of the controller codes in question.

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 311 312

Sem comentários

Lenze Engineer v2.21 Manual do Utilizador Página 300