Lenze EMF2141IB Manual do Utilizador descarregar pdf (Página 24)

Parameter setting

6-2

BA2141 EN 1.0

6.1 Parameter data channel configuration

6.1.1 Parameter data

Parameter data are addressed through Lenze codes. You find a code table in the Operating

Instructions for your controller.

Lenze parameter sets

Parameter sets are for special code saving which is necessary because of different configurations

for different application processes.

The following table informs about the number of parameter sets and how to address them.

82XX 8200 vector

93XX

82XX and 8200 vector controllers have 2 and 4 parameter sets. They can be directly addresse d

through LON.

They are addressed by means of a code-digit offset:

93XX controllers have 4 parameter sets

(depending on the variant) for non-volatile

saving.

• Off set 0 a ddesses parameter set 1 with Lenze codes C0000 to C1999

• Off set 2000 a ddresses parameter set 2 with Lenze codes C2000 to C3999

Another parameter set is in the user

memory of the controller. This is the

No additional parameter sets available.

• Off set 4000 a ddresses parameter set 3 with the

Lenze codes C4000 to C5999

• Off set 6000 a ddresses parameter set 4 with the

Lenze codes C6000 to C7999

After switching on the controller,

parameter set 1 is automatically loaded

into the current parameter set.

Chan

es of the current

arameter set will

If a parameter is available only once (see Operating Instructions for 82XX or 8200 vector), use the

code digit offset 0.

be lost after switching off the controller.

The current parameter set is stored in

Example for C0011 (maximum field f re quency):

C0011 in parameter set 1: Le nze code = 11

C0011 in parameter set 2: L e nze code = 2011

code C0003.

Only the current parameter set can be

directly addressed through LON.

C0011 in parameter set 3: L e nze code = 4011

C0011 in parameter set 4: L e nze code = 6011

The 93XX codes are listed in the

Operating Instructions and the Manual.

Parameter changes

Automatic saving in the controller Automatic saving (can be switched off under C0003) Changes must be saved in code C0003.

All changes made without storing them will

be lost after the controller is switched off.

Process data changes

No automatic saving No automatic saving No automatic saving

Stop!

• For 8200 vector

– Please note that it is not allowed to write parameter data to the EEPROM.

– If you want to cyclically change parameter data, the code must be configured as follows

after every mains switching: C0003 = 0.

• For 82XX

– Please note that it is not allowed to cyclically write parameter data to the EEPROM.

Show/Hide Bookmarks

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 89 90

Comentários a estes Manuais

Sem comentários

Lenze EMF2141IB Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Lenze EMF2141IB