Lenze S94P01B2 Manual do Utilizador descarregar pdf (Página 30)

S94P01B2

Interface

4.5.3 Motor Set-up

Once you are connected to the PostionServo 940 via MotionView a “Parameter Tree”

will appear in the “Parameter Tree Window”. The various parameters of the drive are

shown here as folders and ﬁles. If the “Motor” folder is selected, all motor parameters

can be viewed in the “Parameter View Window”. To view selected motor parameters or

to select a new motor click the section marked “CLICK HERE TO CHANGE”.

S911

MotionView’s “Motor Group” folder and its contents

NOTE

If the drive is ENABLED, a new motor cannot be set. You can only set a

new motor when the drive is DISABLED.

To View selected motor parameters or to make a new motor selection:

•Click“Clickheretochangethemotor”fromtheParameterViewWindow(seegure

above). If you are just viewing motor parameters click Cancel on Motor Parameters

dialog when done to dismiss the dialog box.

•SelectmotorVendorfromtherightlistboxanddesiredmotorfromtheleftlistbox.

•Ifyouwillbeusinga“custom”motor(notlistedinourmotordatabase)goto”Usinga

custom motor” topic in the next section.

•Finally,clicktheOKbuttontodismissthedialogandreturntoMotionView’smainprogram.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 75 76

Sem comentários

Lenze S94P01B2 Manual do Utilizador Página 30