Lenze EMB934x Manual do Utilizador descarregar pdf (Página 128)

Electrical installation

Circuit proposals

Overload protection in case of power peaks



128

EDBMB9340 DE/EN/FR 12.0

5.5.3 Overload protection in case of power peaks

 Note!

When the drive system is dimensioned correctly, no power peaks occur which

could overload the regenerative power supply module.

The behaviour of the drive system described in the following refers to the circuit proposal

and the parameter setting in chapter Controlled shutdown of the drive system" ( 126).

1. If the regenerative power of the controllers cannot be dissipated completely due to

the power peaks, the DC−bus voltage increases.

2. If the DC−bus voltage reaches the upper comparator threshold (Ax = HIGH), the

feedback operation is inhibited (E1 = HIGH).

3. With brake chopper: The redundant power is converted into heat via the brake

choppers.

Without brake chopper: The controllers switch over to the fault OU" (overvoltage).

The drives coast.

4. If the DC−bus voltage has dropped to below the lower comparator threshold

(Ax = LOW), the feedback operation is enabled (E1 = LOW).

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 205 206

Sem comentários

Lenze EMB934x Manual do Utilizador Página 128