Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual do Utilizador descarregar pdf (Página 11)

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014 11

Preconditions

System requirements

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3 Preconditions

3.1 System requirements

[3-1] Sample configuration with a Controller 3200 C

3.2 Setting up communication to the Controller

• Connect the Engineering PC with the controller via a network cable. The »PLC Designer«

accesses the controller via Ethernet.

• Make the IP settings with the »PLC Designer«.

 How to check the communication settings:

1. Double-click the desired controller in the Devices view.

2. Make the desired settings on the Communication settings tab.

•Click the Add gateway button to insert a gateway.

Engineering PC Controller

Hardware PC/notebook PLC (Logic) from firmware V3.8

Operating system Windows XP Windows CE

Required Lenze software »PLC Designer« from V3.8

•Contains the

ApplicationTemplate PackML

• Contains the Lenze library

"L_EATP_ApplicationTemplate.co

mpiled-library"

Runtime software

•Logic

• Motion (for this purpose, the project

data must be updated: "Update

Device")

Further requirements - Depending on the application case:

• CAN-/EtherCAT bus system

• CAN-/EtherCAT node

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 98 99

Sem comentários

Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual do Utilizador Página 11