Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual do Utilizador descarregar pdf (Página 12)

Preconditions

Setting up communication to the Controller

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

•Enter the desired IP address of the controller.

[3-2] Example: Enter the IP address of the Controller, standard setting: 192.168.5.99

3. Click OK to add the controller as gateway.

4. By double-clicking the desired channel (or clicking the Set active path button), set the

channel selected in the device view below the gateway as active path to the controller.

• Thus, all communication actions directly refer to this channel.

• The currently active path is represented in bold in the list and "(active)" is attached:

5. A device represented in italics is set as active path but has not been found during the last

network scan.

 Note!

During initial commissioning, observe the predefined IP address: 192.168.5.99

 Further information can be found in the following documentation:

Controller - Parameter setting & configuration

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 98 99

Sem comentários

Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual do Utilizador Página 12