Lenze E84Dxxxxx Manual do Utilizador descarregar pdf (Página 18)

2Introduction

2.4 Parameter setting and configuration

18

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2.4 Parameter setting and configuration

If you select the safety option in the project view of the »Engineer«, different tabs for the safety

system are available in the workspace. The following illustration shows the tabs for safety

option

30:

[2-1] Tabs of the integrated safety system (here as an example for safety option 30)

Safe parameter transfer

By clicking Safe Transfer on the Safe configuration tab, the Safe Transfer dialog box opens which

provides the function for a safe parameter transfer.

Safe parameter transfer ( 44)

 Note!

Safety-relevant parameters can only be transmitted to the drive-based safety system via

safe parameter setting with the »Engineer«.

The parameter set is stored in the memory module and in the drive-based safety system

with a unique module ID, which must correspond to the effective safety address in the

drive-based safety system.

Tab Information available for

safety soption

10 20 30

Safe configuration This tab serves to make the safe configuration of the drive-

based safety.

Safe configuration

( 22)



Features This tab displays general information on the safety system,

e.g. product name, version, etc.



Documentation This tab serves to add notes and electronic documents to the

drive-based safety system.

• Detailed information on adding documentations can be

found in the »Engineer« documentation in chapter

"Project structure".



1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 69 70

Comentários a estes Manuais

Sem comentários