Lenze E84Dxxxxx Manual do Utilizador descarregar pdf (Página 19)

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05 19

2Introduction

2.4 Parameter setting and configuration

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Service status

If you request the "Send safe data to device" function in the Safe Transfer dialog box via the Send

button, the drive-based safety system changes to the "Service status" which is required for a safe

parameter setting.

Send safe data ( 45)

The service status means:

• The standard stop is active and the drive is safely switched to torqueless operation (STO).

• With safety option 30, the safe inputs are evaluated as OFF state.

• The communication via safety bus is - if possible - active, but passivated.

Supported interfaces for a safe parameter setting

A safe parameter setting with the »Engineer« is supported via the following interfaces:

• Diagnostic interface X70

• CANopen system bus interface

 Note!

• The service status is also active if the parameter set in the memory module does not

correspond to the parameter set in the drive-based safety system during the

initialisation.

• The service status can be exited by reinitialising the drive-based safety system, i.e. the

communication via the safety bus is interrupted.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 69 70

Comentários a estes Manuais

Sem comentários