Lenze E84Dxxxxx Manual do Utilizador descarregar pdf (Página 20)

2Introduction

2.5 Diagnostics & error management

20

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2.5 Diagnostics & error management

LED display

In the "Safety" field in the middle of the LED display on the front of the controller you will get

information on the status of the drive-based safety system:

[2-2] LED display on the front of the controller

',

',

','2

','2

',

',

5'<

(55

96

%UDNH

%865'<

%86(55

/LQN

/LQN

66WDWH

6(UURU

6$FNQZ

6(QDEOH

'59

6WDWXV &RP 6DIHW\ ,2 ,2

Labelling Colour Status Description

LED status displays for the integrated safety system

S-State green off Communication between standard device and safety system

is not possible

blinking Integrated safety system is in the service status

on Communication between standard device and safety system

has been established

S-Error red off Error-free operation

blinking Integrated safety system is not accepted by standard device

on Warning/fault/error

S-Acknw yellow on Parameter set acceptance must be acknowledged

S-Enable yellow blinking Safety function active (non-safe display)

on Controller enabled

 Note!

The status of safety option 10 is only indicated via the "S-Enable" LED display.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Comentários a estes Manuais

Sem comentários