Lenze DDS Target 9300 Servo PLC V8.x Manual do Utilizador descarregar pdf (Página 141)

9300 Servo PLC

Appendix

3.6 Code table

3−135

9300 Servo PLC EN 5.1

Code InformationPossible settingsLCDCode Information

SelectionLenze

LCD

C0362 Sync cycle

System bus: Time interval between 2 sync telegrams

(in preparation)

1 {1 ms} 30

C0363 Sync corr 1 System bus: Sync correction increments

1 0.2 s/ms

2 0.4 s/ms

3 0.6 s/ms

4 0.8 s/ms

5 1.0 s/ms

C0365 DIS:CAN active

Input signal CAN active

0 CAN not active

1 CAN active

C0366 Sync response 1 System bus: Sync response

0 No response

1 Response to sync

No response

PLC responds to a sync telegram by sending the

CAN1_OUT object.

C0367 Sync Rx Id 128 System bus: Sync Rx identifier

Receive identifier of the sync telegram.

1 {1} 256

C0368 Sync Tx Id 128 System bus: Sync Tx identifier

Send identifier of the sync telegram.

1 {1} 256

C0369 Sync Tx time 0 System bus: CAN sync send telegram cycle

 A sync telegram with the identifier of C0368 is sent

with the set cycle time.

0 {1} 65000

0 = Off

C0370 Gateway addr. 0 System bus: Activate SDO gateway remote

parameterisation

The SDO gateway cannot be used to read out codes

>C2000 or codes of the Inverter Drives 8400 and Servo

Drives 9400.

 When selecting a setting 0, all code read/write

accesses will be redirected to the system bus device

with the corresponding node address.

 The codes are accessed via the SDO1 parameter

channel of the target device.

0 {1} 63

0 = remote parameter setting deactivated

C0381 HeartProTime 0 System bus: Heartbeat (slave): HeartbeatProducerTime

Time interval for sending the "heartbeat" message.

 Only relevant for setting C0352 = 3.

 Additional information about the "heartbeat" function

can be found in the Manual for the function library

LenzeCanDSxDrv.lib.

0 {1 ms} 65535

C0382 GuardTime 0 System bus: Node Guarding (slave): NodeGuardTime

Time interval for the status request from the master.

 Only relevant for setting C0352 = 4.

 Additional information about the "node guarding"

function can be found in the Manual for the function

library LenzeCanDSxDrv.lib.

0 {1 ms} 65535

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 168 169

Comentários a estes Manuais

Sem comentários

Lenze DDS Target 9300 Servo PLC V8.x Manual do Utilizador Página 141

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Lenze DDS Target 9300 Servo PLC V8.x