Lenze EMF2133IB Manual do Utilizador descarregar pdf (Página 31)

Commissioning

Before switching on

l 31

EDSMF2133IB EN 5.0

6 Commissioning

During commissioning, system−dependent data as e.g. motor parameters, operating

parameters, responses and parameters for fieldbus communication are selected for the

controller.

In Lenze devices, this is done via codes. The codes are stored in numerically ascending order

in the Lenze controllers and in the plugged−in communication/function modules.

In addition to these configuration codes, there are codes for diagnosing and monitoring

the bus devices.

The codes can be set e.g. via an operating module (keypad) or a PC with the Lenze

parameter setting program »Global Drive Control« (GDC).

6.1 Before switching on

( Stop!

Prior to switching on the mains voltage, check the wiring for completeness,

short−circuit and earth fault.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 133 134

Sem comentários

Lenze EMF2133IB Manual do Utilizador Página 31