Lenze ETC Motion Control Manual do Utilizador descarregar pdf (Página 28)

Getting started

Establishing the communication between PC and ETCHx

Assigning the IP address of the ETCHx

2.4

2.4.4

EDSTCXN EN 2.0

2.4.4 Assigning the IP address of the ETCHx

For communication via a network or a local Ethernet cable, the ETCHx

requires a unambiguous IP address (with subnet mask) that matches the

other nodes. When the control system is delivered, it has a specific, but

random IP address.

The IP address of the ETCHx is assigned via the monitor interface (as

described in the following). This IP address is requested when connections

are established in the ETC−MMI Gateway (¶ 34).

Specify the IP address according to the following general rules for IP

addresses:

If the control system and PC are connected with a local network segment or

via a direct Ethernet connection (without Internet/Intranet connection),

assign IP addresses of class B or class C to the two network stations.

ƒ Addresses of class B are in the range from 128.0.0.0 to

191.255.255.255. The corresponding subnet mask is 255.255.0.0

(default).

ƒ Addresses of class C are in the range from 192.0.0.0 to

223.255.255.255. The corresponding subnet mask is 255.255.255.0

(default).

The gateway address is not relevant here. You can enter a free IP address of

the subnetwork (not 0.0.0.0).

Example IP address Subnet

mask

Gateway

address

This address must be assigned to the ETCHC and

specified as connection parameter in the ETC−MMI

Gateway ^ 34:

181.16.1.10

255.255.0.0 181.16.1.1

This address must be specified in the network

connection of the PC (TCP/IP settings):

181.16.1.11 255.255.0.0 181.16.1.1

) Note!

Do not use any leading zeros in the IP addresses. Otherwise, the

IP address will be interpreted as octa decimal number.

If ETCHx and PC are to be connected with an existing network segment, the

addresses and the subnet mask must be assigned by the network

administrator.

) Note!

If the Ethernet adapter supports 100Base−T technology, "Auto

Select" or "10Base−T" must be set for the "Media Type" property.

Separate (local) network

segment

Existing network segment

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 427 428

Comentários a estes Manuais

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual do Utilizador Página 28

Comentários a estes Manuais

Manuais e produtos relacionados com Software Lenze ETC Motion Control