Lenze ETC Motion Control Manual do Utilizador descarregar pdf (Página 344)

100

101

PLC programming

Project planning

Configuring I/O modules

8.4

8.4.4

344

EDSTCXN EN 2.0

8.4.4.1 Configuring CAN Master (global CAN settings)

Automatic address: The switch should be disabled, otherwise CoDeSys will

allocate the addresses automatically.

ETC106

Baud rate: The baud rate for the CAN Bus must be selected in accordance

with the settings of the connected CAN modules.

) Note!

Entering the baud rate is only enabled for the ETCxM.

For the ETCxC this parameter is without function. Only settings

of the machine constants are possible.

Com. Cycle Period: Will not be evaluated by the control.

Sync. Window Length: Will not be evaluated by the control.

Sync COB−ID: Will not be evaluated by the control.

Node−ID: Enter a "0" here.

Automatic start up: Will not be evaluated by the control.

Support DSP301 ...: Will not be evaluated by the control.

Heartbeat Master: Will not be evaluated by the control.

Basic parameters

CAN parameters

1 2 ... 339 340 341 342 343 344 345 346 347 348 349 ... 427 428

Comentários a estes Manuais

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Manual do Utilizador Página 344

Comentários a estes Manuais

Manuais e produtos relacionados com Software Lenze ETC Motion Control