Lenze TCF Series Manual do Utilizador descarregar pdf (Página 39)

NO. PARAMETER NAME RANGE OF ADJUSTMENT

FACTORY

DEFAULT

(NOTE 1)

57 TB STRIP STATUS (VIEW-ONLY) (N/A)

58 KEYPAD STATUS (VIEW-ONLY) (N/A)

59 TB-30 OUTPUT (VIEW-ONLY) (N/A)

73 HEATSINK TEMP (VIEW-ONLY) (N/A)

INPUT ASSERTION

LEVEL

HIGH (01), LOW (02) HIGH (01)

80 DRIVE MODE

CONSTANT V/Hz (01), VARIABLE V/Hz (02),

CONSTANT V/Hz

(01)

ENHANCED CONSTANT V/Hz (03),

ENHANCED VARIABLE V/Hz (04),

VECTOR SPEED (05), VECTOR TORQUE (06)

81 AUTO CALIBRATION

CALIBRATION NOT DONE (00),

CALIBRATION

NOT DONE (00)

CALIBRATION CYCLE ENABLED (01),

CALIBRATION COMPLETE (02)

82 CURRENT LOOP P GAIN 0.00 - 16.0 0.25

83 CURRENT LOOP I GAIN 12 - 9990 mSEC 65 mSEC

84 STATOR RESISTANCE 0.00 - 64.0 OHMS (NOTE 3) 0.00 OHMS

85 MOTOR RATED SPEED 300 - 65000 RPM 1750 RPM

86 MOTOR RATED AMPS 0.0 - 480 AMPS 0.0 AMPS

87 MOTOR RATED VOLTS 0 - 600 Vac 0 Vac

88 MOTOR BASE FREQ 25 - 500 Hz 60 Hz

91 MOTOR COSINE PHI 0.40 - 0.99 0.80

92 MOTOR INDUCTANCE 0.0 - 2000 mH (NOTE 3) 0.0 mH

93 TORQUE LIMIT 0 - 400 % 100%

94 DRIVE PERSONALITY (NOTE 4) (NOTE 4)

95 MOTOR CURRENT (VIEW-ONLY) (N/A)

96 TORQUE PERCENT (VIEW-ONLY) (N/A)

NOTE 1: Factory defaults are shown for a 60 Hz base frequency. Refer to Parameter 48 for 50 Hz base frequency.

NOTE 3: This parameter is automatically set during the AUTO CALIBRATION function.

NOTE 4: Refer to Section 15 - DESCRIPTION OF PARAMETERS.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 75 76

Sem comentários

Lenze TCF Series Manual do Utilizador Página 39