Lenze TCF Series Manual do Utilizador descarregar pdf (Página 60)

P92 MOTOR INDUCTANCE

This will be automatically adjusted when the AUTO CALIBRATION (Parameter 81) function

is performed. Once the AUTO CALIBRATION function is performed, this setting should not

be changed.

P93 TORQUE LIMIT

When the drive is in VECTOR TORQUE mode (refer to Parameter 80) this parameter sets

the maximum output torque. In this mode, the torque reference source can be the keypad

(s and t buttons), a 0-10 VDC signal, or a 4-20 mA signal (preset speeds cannot be used

as torque references). The drive will run at the fastest speed possible to deliver the desired

torque.

P94 DRIVE PERSONALITY

This parameter will display the drive's "personality" by indicating the voltage and HP rating.

The displayed value is 3 digits.

The ﬁrst digit indicates the voltage (2 = 208/240 Vac; 4 = 400/480 Vac, 5 = 480/590 Vac). If

the drive is rated for single-phase and three-phase input (model numbers that end in "Y"),

the left bottom decimal point will illuminate to distinguish it from a three-phase only model.

Refer to the examples herein.

The second and third digits indicate the HP rating (01 = 1 HP, 02 = 2 HP, etc). If the drive's

HP rating is 0.5, 1.5, or 7.5, the bottom right decimal point will be illuminated. Refer to the

examples herein.

Example 1: The displayed value is "405". The "4" indicates that the drive is a 400/480 Vac

model, and the "05" indicates that it is rated 5 HP.

Example 2: The displayed value is "2.1.5". The "2" with the bottom left decimal point

illuminated indicates that the drive is a 208/240 Vac model that can accept single-phase or

three-phase input. The "1.5" indicates that the drive is rated 1.5 HP.

Example 1

Example 2

NOTE

If the personality stored on the EPM does not match the drive model, the drive

may trip into a "bF" fault. Refer to Section 13.2.

P95 MOTOR CURRENT

This displays the current (in amps) that the motor is drawing.

P96 MOTOR TORQUE

This displays the torque (in %) that the motor is generating.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 75 76

Sem comentários

Lenze TCF Series Manual do Utilizador Página 60