Lenze E84DGFCC Manual do Utilizador descarregar pdf (Página 32)

Communication manual 8400 motec CANopen

Commissioning

Possible settings via DIP switch

32 L EDS84DMOTCAN EN 3.0 - 11/2011

6.3 Possible settings via DIP switch

[6-1] DIP switch

6.3.1 Setting the baud rate

The baud rate ...

 must be the same for all networked CANopen nodes;

 can be set via the DIP switches a...c or via the »Engineer« (code C00351

Settings in the Lenze »Engineer«

( 34)

The DIP switches serve to ...

 Setting the baud rate

( 32) (switches: a ... c)

 Setting the CAN node address

( 33)

(switches: 1 ... 64)

Lenze setting: All switches OFF

 Note!

• The DIP switches can only be accessed when the drive unit is detached from

the communication unit. Loosen the four fixing screws at the drive unit.

Observe the notes in the mounting instructions.

• Switch off the voltage supply of the controller and the external supply of the

communication unit before starting with the dismounting of the drive unit.

• The DIP switches are only read in when the device is switched on.

DIP switch position Baud rate

c b a

ON OFF ON 20 kbps

OFF ON ON 50 kbps

OFF ON OFF 125 kbps

OFF OFF ON 250 kbps

OFF OFF OFF 500 kbps

ON ON OFF 800 kbps

ON OFF OFF 1000 kbps

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 110 111

Sem comentários

Lenze E84DGFCC Manual do Utilizador Página 32